Product category
Optical connectors are precision mechanical interfaces that align two fiber cores — each around nine microns wide — accurately enough for light to cross the joint with minimal loss. Ferrule quality, end-face geometry and adapter alignment decide how much of the optical budget every mating consumes.
The category includes the SC, LC, FC and ST interface families with zirconia ceramic ferrules, the adapters that mate them through panels and outlets, and field-installable connectors for terminating drop cables at the subscriber end without a splicer. Flat-polished UPC end-faces suit general transmission, while 8-degree angled APC end-faces deflect reflections into the cladding and are the default wherever PON and RF-overlay return-loss limits apply. Interfaces are designed to align with the IEC 61754 series, with performance graded per IEC 61755.
Selection guide
Standardise on as few connector types as the network allows — LC where port density rules, SC/APC across PON distribution — and never mix polishes on one link. Use field-installable connectors for fast subscriber turn-up and splice-on pigtails where lowest loss matters, and make inspect-and-clean before every mating a standing rule: contamination remains the most common cause of failed links.
Catalogue
Select up to three products to compare their typical specifications side by side.
ModelPSK-CON-102Available
Field-installable SC/APC connector that terminates drop cable at the subscriber's premises in about two minutes — no epoxy, no polishing. A factory pre-polished ferrule and internal mechanical splice deliver APC-grade reflectance at the doorstep.
ModelPSK-CON-101On request
Small-form-factor LC connector with a 1.25 mm zirconia ferrule for high-density single-mode termination. Epoxy-and-polish construction for pigtails, patch cords and factory assemblies, at half the panel footprint of SC.
Solutions
Operators extending fiber to the home must connect thousands of subscribers across feeder, distribution and drop layers while keeping per-home cost predictable. This solution covers the complete FTTH passive plant — from central-office termination through PLC split points to the subscriber terminal — with one coordinated product set.
View solutionData centers concentrate thousands of fiber links into a few rows, where congestion, poor labeling and uncontrolled bend radius directly degrade availability. This solution structures cabinet, frame and patch-cord infrastructure so density stays manageable and every link remains documented and re-patchable.
View solutionEnterprise campuses need building-to-building backbones that outlive several generations of active equipment. This solution builds the campus optical layer on open standards — outdoor backbone cable, structured termination and documented patching — so upgrades replace electronics, not installed plant.
View solutionModern buildings converge internet, CCTV, access control and building management onto shared infrastructure, straining separate copper systems. This solution carries all services over one optical backbone — riser distribution, floor-level terminal boxes and ONU endpoints — reducing pathway congestion and simplifying long-term operation.
View solutionGet a quote
Send us your quantities and project details — our team responds with availability, packaging and regional pricing.